New Rear Sights

Index | ToC | Plane | Ohio

Alliance Hobby

PO BOX 2901
ALLIANCE OH 44601
UNITED STATES

sales@alliancehobby.com | Order Status

Worldwide Sales of Crosman Parts & Upgrades

FREE USA Shipping, Expedited USA & Cheap International Rates

Simple HTML. No ads. No popups. No spam emails.

Mail & other payment methods.
Can't find what you need? Contact me!

NEW PLASTIC REAR SIGHT FOUR PIECE SET
FOR PLASTIC AND STEEL BREECHES

CUSTOM APERTURES AND HEIGHTS AVAILABLE

Finally! A plastic sight aperature as low as the LPA MIM! Read below.

This listing is for a four piece rear sight set for either the plastic or steel breeches. As such, it they will fit dozens of available crosman airguns. If your 2240 2250 2260 1377 1322 Drifter, etc, etc (Custom Shop too) has the normal plastic breech or a steel breech, these will fit.

They may or may not fit the Marauder breeches. If you have my Shaved Steel Breech, then you would want the Plastic Breech rear sight (which is why I shave it to begin with).

I'll say that again. If you have the Shaved Steel Breech, you do NOT want the Steel Breech Rear Sight. You want the Plastic Breech Rear Sight, because it has the flat bottom.

Now. Onto the details.

Because the aperture is fixed on these sights, I am including these as a four pack. The apertures sit 9, 10, 11 and 12mm from the bottom-most portion of the sight (where the sight mates to the breech). You will receive four sights and you can swap them as you see fit.

I have been asked for years for a rear sight that sits as low as the LPA MIM. People keep having to buy ridiculously tall front sights to compensate for too-tall rear sights. The 9mm aperture in the steel breech kit actually sits about 0.2mm LOWER than the LPA.

These come with 3mm diameter holes. I can make other diameters and other heights at additional cost.

Full disclaimer: These are, admittedly, weaker than injection molded plastic. You can break these. Do not overtighten. Do not beat them up.

Related Kits